Garage door motors are essential to the proper functioning of garage doors. When these motors start to malfunction, it can cause major inconvenience and safety risks. Replacing a garage door motor requires some technical knowledge, so it is important that this job is done carefully.
The first step in replacing a garage door motor is to identify the type of system you have. This will determine the replacement parts you need and how complex the installation will be. Generally speaking, there are two types of systems: chain drive and belt drive systems. Chain drives are less expensive systems but require more maintenance than belt drives, which tend to be quieter and smoother-running but more expensive as well.
You’ll also need to remove the old motor from its mounting bracket before proceeding with the garage door motor replacement. It’s recommended that you use an adjustable wrench for this purpose so that you can loosen all four screws that secure it in place without damaging them or your new motor during removal. Once successfully removed, you can then install your new motor on its bracket with screws provided by your manufacturer or available at hardware stores if needed depending on what type of system you have installed in your home’s garage space
After connecting power wires from either an exterior wall outlet or fuse box into the back of your newly installed motor unit, turn on power switch located near light switches within reachable distance away from unit itself; then press down button located on remote control device until power indicator light turns green signaling successful connection between two components motor remote. Once completed successfully next step would be testing out functionality by opening/closing garage door several times using both manual pull cord attached near bottom center area as well as remote control device under same circumstances; if all works properly then move onto next phase.
To finish up replacing a garage door motor make sure all connections are working properly including any necessary adjustments made concerning sensors located around frame area top + sides. Securely fasten any loose pieces such as brackets holding up opener itself together with nuts & bolts provided if needed after making sure everything else has been done correctly; double check functions once again via pulling cord + pressing down button just like before starting whole process earlier; finally replace cover plate attaching back over top when done testing out movements for last time.
In conclusion, garage door motor replacement requires some technical know-how and careful execution in order to ensure smooth operation and safety afterwards – following steps listed above should help homeowners get job done effectively without much difficulties encountered along way.
